Questions? Call 1-386-586-3650
DEI 492T Keyless Entry Alarm Remote Start Remote EZSDEI467 EZSDEI492 EZSDEI493 EZSDEI493C
DEI 492T Keyless Entry Alarm Remote Start Remote EZSDEI467 EZSDEI492 EZSDEI493 EZSDEI493C

If your remote has a circuit board number of DT8B, DT8C, or RT4A then the remote is a 492T regardless of what FCC ID is printed on the remote's case.  It could be EZSDEI467, EZSDEI492, EZSDEI493, EZSDEI493C or something else if the remote had

From: $39.95 View Product
The below Programming Procedure is available to program any remote keyfob whose circuit board number is DT8B, DT8C, or RT4A, regardless of whether the fob's FCC ID is EZSDEI493C or EZSDEI467 or EZSDEI492, EZSDEI493 or something else, when used on these systems: Automate 2, Automate 3+, Automate 5+, Equalizer 2, Valet 710T, Hornet 718T, Hornet 719T, Python 650, Python 750, Sidewinder 5000, Sidewinder 6000, Wasp 718W, Viper 300+, Viper C 50, Viper 500+, Viper 500NX. In an effort to enter into the Learn Routine, the system’s Valet/Programming button should be plugged into the blue port.

Channel 1
is designed for Arm, Disarm, and Panic. Channel 2 is made for Silent Mode or Remote Valet mode when the system was set up for it. Channel 3 is optional and only used in case your system was wired for a third channel.

1.
Open up the driver's door.
2.
Stick key in ignition and turn towards the ON/RUN position.
3.
Press the valet button One time, push once more and hold it until step 5. The system will chirp once.
4.
Press button #1 on the remote. 1 chirp verifies channel has been learned.
5.
Let go the valet button. Remove key in order to complete.

If your system uses channel 2:
1.
Open up the driver's door.
2.
Stick key in ignition and turn to your ON/RUN position.
3.
Push the valet button TWICE, press once more and hold it until step Five. The system will chirp once.
4.
Press button #2 on the remote. 1 chirp confirms channel has been learned.
5.
Let go the valet button. Take out key to conclude.

If your system uses channel 3:
1.
Open the driver's door.
2.
Insert key in ignition cylinder and switch to the ON/RUN position.
3.
Push the valet button THREE TIMES, press again and hold it until step Five. The system will chirp once.
4.
Push both buttons together on the remote keyfob . 1 chirp confirms channel has been learned.
5.
Let go of the valet button. Take out key to finish.
TEASoftware