Sidewinder 6000 Programming Instructions

The subsequent Programming Method enables you to add any fob whose circuit board ID is DT8B, DT8C, or RT4A, whether the keyfob's FCC ID is EZSDEI493C or EZSDEI467 or EZSDEI492, EZSDEI493 or something else, when used on these systems: Automate 2, Automate 3+, Automate 5+, Equalizer 2, Valet 710T, Hornet 718T, Hornet 719T, Python 650, Python 750, Sidewinder 5000, Sidewinder 6000, Wasp 718W, Viper 300+, Viper C 50, Viper 500+, Viper 500NX. For you to get into the Learn Routine, the system’s Valet/Programming button should be connected to the blue port.

Channel 1 is designed for Arm, Disarm, and Panic. Channel 2 is designed for Silent Mode or Remote Valet mode in case the system was wired for it. Channel 3 is optional and only used when your system was wired for a third channel.
1. Open the driver's door.
2. Stick key in ignition cylinder and switch towards the ON/RUN position.
3. Press the valet button One time, press once more and hold it until step 5. The system will chirp once.
4. Push button #1 on the remote. A single chirp indicates channel has been learned.
5. Let go of the valet button. Take out key to conclude.

If your system uses channel 2:
1. Open up the driver door.
2. Insert key in ignition cylinder and switch to your ON/RUN position.
3. Push the valet button TWO TIMES, push once more and hold it until step 5. The system will chirp once.
4. Push button #2 on the remote. One chirp confirms channel has been learned.
5. Release the valet button. Remove key to end.

If your system uses channel 3:
1. Open the driver door.
2. Put key in ignition cylinder and switch to the ON/RUN position.
3. Push the valet button THREE TIMES, press once more and hold it until step Five. The system will chirp once.
4. Push both buttons together on the remote fob . A single chirp verifies channel has been learned.
5. Release the valet button. Take out key to end.