Questions? Call 1-386-586-3650
DEI 492T Keyless Entry Alarm Remote Start Remote EZSDEI467 EZSDEI492 EZSDEI493 EZSDEI493C
DEI 492T Keyless Entry Alarm Remote Start Remote EZSDEI467 EZSDEI492 EZSDEI493 EZSDEI493C

If your remote has a circuit board number of DT8B, DT8C, or RT4A then the remote is a 492T regardless of what FCC ID is printed on the remote's case.  It could be EZSDEI467, EZSDEI492, EZSDEI493, EZSDEI493C or something else if the remote had

From: $39.95 View Product

The following Programming Method may be used to program any keyfob whose circuit board ID is DT8B, DT8C, or RT4A, regardless of if the keyfob's FCC ID is EZSDEI493C or EZSDEI467 or EZSDEI492, EZSDEI493 or anything else, when being used on these systems: Automate 2, Automate 3+, Automate 5+, Equalizer 2, Valet 710T, Hornet 718T, Hornet 719T, Python 650, Python 750, Sidewinder 5000, Sidewinder 6000, Wasp 718W, Viper 300+, Viper C 50, Viper 500+, Viper 500NX. So that you can enter the Programming Procedure, the system’s Valet/Programming button should be connected to the blue port.

Channel 1 is made for Arm, Disarm, and Panic. Channel 2 is for Silent Mode or Remote Valet mode when the system was wired for it. Channel 3 is optional and only used if your system was wired for a third channel.

1. Open the driver's door.
2. Put key in ignition cylinder and turn towards the ON/RUN position.
3. Push the valet button ONCE, press once more and hold it until step 5. The system will chirp once.
4. Push button #1 on the remote. One chirp verifies channel has been learned.
5. Let go the valet button. Remove key in order to complete.

If your system uses channel 2:
1. Open the driver's door.
2. Insert key in ignition and switch with the ON/RUN position.
3. Push the valet button TWO TIMES, push once more and hold it until step 5. The system will chirp once.
4. Press button #2 on the remote. A single chirp indicates channel has been learned.
5. Let go the valet button. Take out key in order to complete.

If your system uses channel 3:
1. Open up the driver's door.
2. Stick key in ignition and turn into the ON/RUN position.
3. Push the valet button THRICE, press again and hold it until step 5. The system will chirp once.
4. Press both buttons together on the remote . One chirp verifies channel has been learned.
5. Release the valet button. Remove key in order to complete.

TEASoftware