The following Programming Method can be used to add any keyfob whose circuit board ID is DT8B, DT8C, or RT4A, whether the keyfob's FCC ID is EZSDEI493C or EZSDEI467 or EZSDEI492, EZSDEI493 or anything else, when used on these systems: Automate 2, Automate 3+, Automate 5+, Equalizer 2, Valet 710T, Hornet 718T, Hornet 719T, Python 650, Python 750, Sidewinder 5000, Sidewinder 6000, Wasp 718W, Viper 300+, Viper C 50, Viper 500+, Viper 500NX. So that you can enter into the Programming Routine, the system’s Valet/Programming button must be attached to the blue port.

Channel 1 is designed for Arm, Disarm, and Panic. Channel 2 is made for Silent Mode or Remote Valet mode if the system was set up for this. Channel 3 is optional and only used in the event your system was set up for a 3rd channel.
1. Open the driver door.
2. Put key in ignition cylinder and switch into the ON/RUN position.
3. Press the valet button One time, press again and hold it until step Five. The system will chirp once.
4. Press button #1 on the remote. 1 chirp indicates channel has been learned.
5. Let go the valet button. Remove key to conclude.

If your system uses channel 2:
1. Open the driver door.
2. Insert key in ignition cylinder and turn to your ON/RUN position.
3. Press the valet button TWICE, press again and hold it until step Five. The system will chirp once.
4. Press button #2 on the remote. One chirp confirms channel has been learned.
5. Release the valet button. Take out key to finish.

If your system uses channel 3:
1. Open the driver door.
2. Stick key in ignition and turn to your ON/RUN position.
3. Press the valet button THRICE, press once more and hold it until step Five. The system will chirp once.
4. Push both buttons together on the transmitter . One chirp confirms channel has been learned.
5. Let go of the valet button. Remove key to conclude.